Inverting Amplifier
===================
It is very easy to make an amplifier using an Operational Amplifier IC. The amplification factor is decided the
ratio of two resistors.

**Objective**

Wire an Inverting amplifier using an Op-Amp, like uA741 or OP07,  and test it.

**Procedure**

.. image:: schematics/opamp-inv.svg
	   :width: 300px

-  Make the connections on bread board as shown in the figure.
-  Set WG amplitude to 80 mV and frequency to 1000 Hz
-  Enable A1 and A2, and set ranges to 1V
-  Enable the amplitude and frequency displays of A1 and A2.
-  Make connections and calculate the voltage gain from the output
-  Change gain by changing the resistor values.

The amplitude gain and and the phase difference can be observed from the output below.

.. image:: pics/opamp-inv-screen.png
	   :width: 500px

**Discussion**

Using expeyes, it is not possible to study the high frequency response.

